How to Renew Your Fiberglass Bathing Tub

Replacing a fibreglass chopped strand mat bathing tub are often consume a lot of time, labor, and money. Some householders elect to leave their current tub and shower whereas upgrading the remainder of the bath room. An answer to giving your fibreglass bathing tub a new look is to renew it. Refinishing a fibreglass bathing tub could be a comparatively simple project, however it will need operating with completely different chemicals. Follow these steps to renew a fibreglass bathing tub.

Step one - Sand fibreglass bathing tub

Begin refinishing the fibreglass bathing tub by sanding the whole surface. Use a small palm sander with fine grit sandpaper. The palm sander is far higher for this project than a bigger sander thanks to its manoeuvrability. Cover the whole surface and don't gouge the fibreglass.

Step two - Clean Tub Surface

Thoroughly clean the surface. Use a clean cotton rag and acetone to rub the whole surface. Doing thus can take away greasy residue, permitting the coloured gel coat to stick properly. If any dirt remains on the surface, it'll have a rough texture when the coating has been applied.

Step three - Tape encompassing space

Cover the area with plastic and tape to seal it. Doing this can defend the bathtub from dirt, and also the walls and fixtures from over spray.

Step four - Spray Gel Coat on fibreglass bathing tub

Wear a respirator mask as the fumes are terribly toxic. Fill the gun with the specified gel coat and spray it equally. It ought to be thick, however not very thick that it drips. Spray the coat without fear to covering the whole surface.

Step five - Spray Second Coat

Once the primary coat dries till it's tacky to the touch, spray a second coat. The second coat ought to be heavier and cover the whole surface. don't stop the spray gun in any space.

Step six - Spray Third Coat if Necessary

Sometimes the second coat of gel doesn't fully cover the surface. Let it dry till it's tacky to the bit and apply a 3rd coat. you ought to not have to be compelled to apply any longer.

Step seven - Let It Dry and Harden

As the gel coating on the fibreglass bathing tub dries, it'll harden. reckoning on the sort of gel, color, and gloss, it'll add a completely style to your bath room. Once the gel hardens, wipe it with a clean rag and acetone. Take away the tape and plastic, then get pleasure from the refinished bathing tub.

And if you need fiberglass chopped strand mat to repair the bathing tub, you can go to zccyfiberglass.com to find it.